Afficher panier (0 Article) Mon compteAfficher bloc-notesAller à la caisse

One Step™

One Step™ is a convenient, economical liquid sealing agent and release agent in one. This low odor, low viscosity formula is offered as a “one step” alternative to using a sealing agent followed by a release agent during the mold making process using Smooth-On urethane mold rubbers. One Step™ will facilitate the release of cured urethane mold rubber from plaster, concrete, stone, brick, marble, limestone, wood, metal and other surfaces. Do not use on modeling clays.

  • One Step /360 gram

    Agent d'étanchéité et agent de démoulage en un, liquide, pratique et économique Cette formule ininflammable et sans COV est proposée comme une alternative «en une étape» à l'utilisation d'un agent de scellement suivi d'un agent de démoulage pendant le processus de fabrication de moules en utilisant des moules en caoutchoucs/uréthane Smooth-On. One Step® facilitera la libération du moule ne caoutchouc/uréthane durci à partir de plâtre, béton, pierre, brique, marbre, pierre à chaux, bois, métal et autres surfaces. Ne pas utiliser sur les argiles à modeler.

    30,70 EUR (Prix exclusif 21% TVA)

Features
Low Viscosity Liquid – goes on easily and thoroughly coats any surface when used as directed
Easy To Use – Apply with brush or Kwikee™ pressurized sprayer
Non-Hazardous formula – Does not incur hazardous shipping costs
Economical – Buy one product, not two
Instructions
Safety - Use in a properly ventilated area (“room size” ventilation). Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk. Use in low humidity environments. High humidity will slow evaporation of solvents. Application surface should be clean, dust free and dry. Shake container well before each use.

Store and use material at room temperature (73°F/23°C).

How To Apply - Use a dry brush to apply thorough thin coating of One Step™ over entire surface of model and any surfaces that will contact the mold rubber. Brush into deep detail and undercuts on the model.

Do not allow to pool. Blow off excess with compressed air. Let dry 15 minutes. Apply a second coating and let dry 30 minutes. Mix and apply urethane rubber as directed by the rubber product technical bulletin.

Note: if sealing an extremely porous surface (such as pressed brick), apply 3 coats of One Step™ before applying mold rubber.

Because no two applications are the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.

Naviguer par application

Ces produits sont classés par application telles que, le moulage du corps humain, le moulage, les tirages, les produits transparents, la restoration, le prototypage, etc...

  • Moulage

    Une gamme de matériaux de moulage souples et rigides.

  • Tirage

    Une large gamme de matériaux de tirage souples et rigides

  • special properties

  • Matériaux composites

    Résines et fibres pour la construction en matériaux composites.

  • Mousses

    Mousse PU flexible liquide, mousse PU rigide liquide, blocs de mousse PU rigide et mousse de latex.

  • Restauration

    Matériaux pour la restauration des ornements et des bâtiments, à l'intérieur et à l'extérieur.

  • Prototypage

    Matériaux utilisés pour le prototypage rapide.

  • Textile

  • Cosplay

    Products to make your own Cosplay Costumes and Props!

Informations générales Options d'envoi Costumer Projects Marques Applications Branches